Adam Equipment CQT1751GR User Manual page 13

9) To review the 1
stored into the memory simply press the [Recall / Tare] key to scroll through the
various weights. These are stored in the memory even if the scale has been
switched off so you can tell if only one stored weight is in the memory that you
need to complete the weighing of the screened grain, if 2 stored weights are in the
memory but it does not show percentage if you press the [S/P CE] key it will
calculate the percentage.
10) After completing the test you must clear the memory. This is done by pressing and
holding down the [S/P CE] key for 2 seconds until "Clear" is displayed on the scale
and then release the [S/P CE] key.
11) If the balance is turned off during the weighing process when it is turned on again
it will have kept the stored information in the memory so that you could then
complete the tests without having to start again due to a loss of power.
©Adam Equipment Company 2009
st nd
and 2 stored weight and percentage values that have been
13