Installing The Disk Drives - Advantech IPC-690 User Manual

2.6 Installing the disk drives

1. Remove the disk drive's cover by pushing the square area on the lower cover on the front panel and
also opening the filter cover, as shown in figure 2.6 below.
2. Unscrew the 4 screws on the front panel and take off the plastic panel from the chassis. Unscrew the
3 screws on the side cover and slide it towards the rear. Please refer to figure 2.6 below.
3. Punch out the disk cover of the plastic cover with your fingers. See figure 2.7 below.
8 IPC-6908 User's Manual
2.6 Removing the cover for disk drive installation
2.7 Punching out the disk cover