3.4
Installing a Hard Disk
The procedure for installing a hard disk into the UNO-2362G is displayed below.
Please follow these steps carefully. Please note: the system is not compatible with
+12V HDD.
Please use an HDD with a lower power input.
1.
Remove the power cord.
2.
Unscrew the four screws from the bottom cover.
3.
Screw the HDD onto the bottom cover.
4.
Connect the SATA signal cable to CN9 and SATA power cable to CN8. Then
connect the other side of the cable to the SATA hard disk.
15
UNO-2362G User Manual