Table of Contents
Advertisement
Chapter 2 System Setup
Setting up your IPC-6908 requires only a screwdriver and a small amount of time. Before you begin,
you should also gather together all of the cards you plan to install, as well as the disk drives you plan
to use.
The doors are located on the chassis front cover, providing access to the control panel. This offers the
disk drive and air filter protection against damage, and allows for easy accessibility. The control panel
functions include: CPU reset switch and alarm reset switch on front, power on/off switch on back and
five LED indicators to assist in monitoring system status. On the rear panel, there is a ground point
(earthing point) located on the bottom right hand corner. This provides a ground for the whole system
and is attached via a screw.
WARNING:
2.1 Removing the cover
Unscrew the two thumbscrews on the rear, and then slide the cover toward the rear chassis. See
figure 2.1 below:
Disconnect all power from the chassis before you install the CPU
cards. Unplug the power cord from the wall, do not just turn off
the power switch. If you are not sure what to do, take the job to
an experienced professional.
2.4 Removing the cover
IPC-6908 User's Manual 5
Advertisement
Table of Contents
