2N Helios IP Uni Installation Manual page 11

®
1.5 2N
®
2N



You have to know the IP address of your device to log in to the integrated web server.
By default, 2N
obtains the IP address automatically if a properly set DHCP server is available in your
LAN. If no such DHCP server is available, you can operate 2N
static IP address mode. Refer to the 2N
configuration details.
If your device remains inaccessible (you have forgotten the IP address, or the LAN
configuration has changed, for example), change the LAN settings using the buttons
on the device.
Static/Dynamic Address Setting Mode Switching
In case your 2N
the modes using one button only.





Note: The 15-times-1 sequence must be entered within 30 seconds after the first
sound signal for security reasons. The inter-digit delay may be 2s at most
The static IP address mode will be switched into the dynamic IP address mode and
vice versa upon restart.
Helios IP Uni Configuration
Helios IP Uni Use a PC equipped with any web browser to configure:
Launch your web browser (Internet Explorer, Firefox, etc.).
Enter the IP address of your intercom (http://192.168.1.100/, e.g.).
Log in using the Admin user name and 2n password.
®
Helios IP Uni is switched into the dynamic IP address mode, i.e. it
®
Helios IP Uni device is equipped with 1 or 2 buttons, you can switch
®
Connect 2N Helios IP Uni to the power supply (or, disconnect and reconnect
it if already connected).
Wait for the first acoustic signal
Press button 1 fifteen times.
The acoustic signal
Wait until the device is restarted automatically.
2N® Helios IP Uni Configuration
®
Helios IP Configuration Manual for
.
indicates mode switching.
®
Helios IP Uni in the
1.5