Table of Contents
Advertisement
5.3 Separation Paper
If you use "4.6 Job Separation", specify the feed tray in which the separation paper is loaded.
Settings
The separation paper can be used even if the size and the orientation are different from those of the printer paper.
OFF
Standard Feed Tray
Feed Tray 1
Feed Tray 2
• The separation paper tray is used exclusively for Job Separation. If "Menu 6 Feed Tray Selection" is set to "Auto" and "Menu
4.4 Feed Tray Relay" is set, this feed tray is not used for printing.
• If the separation paper tray runs out of paper during printing, no-paper error will be displayed and printing stops temporarily.
• If a HC Finisher is connected, paper in the separation paper tray can be added as a front cover or a back cover by using the "Add
cover" function of the HC Finisher. In this case, specify the tray in which cover sheets are loaded. If "OFF" is set, an error will
be displayed when printing is performed.
Caution in the following case
If paper larger than the paper for printing or paper of a different orientation is specified as sep-
aration paper, the stack guides are spread according to the larger paper size. Printed paper,
therefore, may not be arranged properly.
1
Use steps 1 to 4 ( p.2-31) to display
"Administration."
2
Press the
"Separation Paper."
3
Press the OK Key.
The submenu of separation paper appears.
2-36
The separation paper tray is not specified. Printing stops for a few seconds in place
of insertion of separation paper.
The Standard Feed Tray is used for separation paper.
Feed Tray 1 is used for separation paper.
Feed Tray 2 is used for separation paper.
or
key to display
4
Press the
or
5
Press the OK Key.
When the screen in step 1 reappears, you can continue
setting.
To exit the setting, press the PRINT/PAUSE key.
key to set.
Advertisement
Table of Contents
