Setting Up The Paper Receiving Tray - Riso HC5500T User Manual

Setting Up the Paper Receiving Tray

Set the Paper Receiving Tray.
(This procedure is not required when a finisher is connected.)
The Side Guides and the End Guide move automatically to the optimum positions according to the printing paper size. Fine position
adjustment can be performed on the Control Panel. For details, refer to "4.8 Paper Ejection" p.2-25 of the menu setting.
1
Open the Paper Receiving Tray in the
direction shown by the arrow until it
stops.
2
Raise the Side Guides.
3
Adjust the Arrangers.
Normally, when printing onto B4 or larger paper, take
out the Paper Arrangers. Paper arrangement depends
on the paper firmness and so on. Adjust the Paper
Arrangers as needed.
1-16
4
Raise the End Guide.
5
Adjust the position of the End Guide
Cushion.
Use the Paper Feed Pressure Adjustment Lever to set
the cushion to [NORMAL] or [CARD] according to
the paper quality.
Do not pull out the Cushion from the Cushion Stand.
"Paper Feed Pressure in Standard Feed Tray" p.1-14
!
When printing onto paper larger than 320
× 432 mm (12
guides.
At this time, set "4.8.2 Stack Guide"
( p.2-26) of the menu setting to "OFF."
5
/ " × 17"), fold all the
8