Filter - Sharp IG-CH2E Operation Manual

FILTER

Even if the FILTER CLEAN light (orange) does not light, it is recommended to
carry out the cleaning once a week.
1
Remove the fi lter.
The filter is attached to the rear
side of the main unit.
Clip the tabs on both sides of the
fi lter and pull it out.
2
Clean up the fi lter.
Gently vacuum the dust attached to
the fi lter with a vacuum cleaner.
Do not press the fi lter forcibly with a vacuum
cleaner. Otherwise, it is damaged.
<For Stubborn Dirt>
Remove and rinse in water. (Use a soft sponge if the dirt does not come off
easily.) And dry it at the sun shadow place.
3
Set the fi lter on the main unit.
Insert the fi lter until the stopper of tab is inserted into the main unit
surely.
Stopper
Do not operate the product while the fi lter is removed.
The dust comes in the main unit and it may cause a failure.
4
Press the ON/OFF button
for 3 seconds.
The FILTER CLEAN light flashes twice and
go off. Even if the FILTER CLEAN light is
off, press ON/OFF button for 3 seconds after
cleaning.
If the FILTER CLEAN light (orange) lights
Tabs
Filter
E-9
2
1
1
Filter
ON/OFF
button