Plasmacluster Ion Generator OPERATION MANUAL Device of this mark is a trademark of Sharp Corporation. Plasmacluster is a registered trademark or a trademark of Sharp Corporation. IG-CH2J...
..........E-13 TROUBLESHOOTING ......E-14 FOR CUSTOMER ASSISTANCE • IG-CH2J decomposes and removes the bacteria attached to the helmet with the Plasmacluster Ion and controls the generation of odour, however, cannot remove the odour sinking into the helmet. • IG-CH2J cannot create a completely sterile environment.
• Only a Sharp Authori�ed Service Center should service this Plasmacluster Ion Generator. Only a Sharp Authori�ed Service Center should service this Plasmacluster Ion Generator.
CAUTIONS CONCERNING OPERATION: • Do not ride the main unit and do not sit on or lean it, it may cause injury or malfunction. Do not ride the main unit and do not sit on or lean it, it may cause injury or malfunction. •...
PARTS NAME MAIN UNIT Louver Suction port CONTROL PANEL OPERATION light FILTER CLEAN (blue) light (orange) ON/OFF button AC ADAPTER AC plug DC plug (Unit Connection Plug)
INSTALLATION GUIDE Connection of AC adapter and installation of main unit Insert the DC plug of AC adapter in the DC jack of the main unit. DC jack DC plug Insert the AC plug of AC AC plug adapter in the outlet. AC adapter Place the main unit at the level place in the room.
OPERATION light If the odour cannot be removed suffi ciently after the product is operated for 8 hours or more, the helmet may absorb the odour. Use IG-CH2J after removing the absorbed odour by cleaning service. Then, newly attached bacteria is...
CLEANING AND MAINTENANCE At the cleaning or maintenance, stop the operation and pull out the plug of AC adapter for connecting the main unit. CABINET At least once a month Wipe off the taint with a soft cloth. <For Stubborn Dirt> Using clean soapy water, wipe o ff t h e c l e a n i n g s u b s t a n c e completely.
FILTER If the FILTER CLEAN light is (orange) Even if the FILTER CLEAN light (orange) does not light, it is recommended to carry out the cleaning once a week. Remove the fi lter. The fi lter is attached to the rear of the main unit.
PLASMACLUSTER ION GENERATING UNIT It is recommended to carry out the cleaning once every 6 months. Remove the louver. Hold the main unit with a hand and then pull out the louver. Louver Remove the cleaning brush. Remove the cleaning brush attached to the main unit. Сleaning brush Clean up the needle electrode of the Plasmacluster Ion Generating Unit.
Page 13
Attach the cleaning brush. Attach the cleaning brush to the pin of the cabinet. Attach the louver. Hold the main unit with a hand and attach the louver to the cabinet. Louver Cabinet Do not operate the product while the louver is removed. The strip of the helmet or other item touches the electrode of the Plasmacluster Ion Generating Unit and it may cause a failure.
FILTER CLEAN light • Failure • The OPERATION light (blue) and Unplug the AC adapter and contact the FILTER CLEAN light (orange) the store you purchased or Sharp are fl ashing. Authori�ed Service Center. OPERATION light FILTER CLEAN light E-13...
Page 20
SHARP CORPORATION OF AUSTRALIA PTY.LTD. A. B. N. 40 003 039 405 1 HUNTINGWOOD DRIVE, HUNTINGWOOD, N.S.W. 2148 P.O.BOX 6827, BLACKTOWN. N.S.W. 2148 www.sharp.net.au SHARP CORPORATION OF NEW ZEALAND LIMITED 59 HUGO JOHNSTON DRIVE, PENROSE, AUCKLAND www.sharp.net.nz Printed in China TINS-A515..RZ 11.-...
Need help?
Do you have a question about the Plasmacluster IG-CH2J and is the answer not in the manual?
Questions and answers