Whirlpool ACM 631 IX Installation Instructions Manual page 10

HOW TO OPERATE THE OVEN
Use of Electronic Programming Clock Adjustment of Day Hour
"A" symbol will start to flash after it is connected to the electrical resource. Press (+) and (-) keys at the same time. It is also possible
to adjust (to increase or to reduce) the time by pressing to these keys.
Alarm / Time Setup
This function can be used as time set up and alarm when wished. "Mode" key must be pressed until "
led indicator lamp will start to light. The wished period interval is adjusted via "+" and "-" keys. The
wished time remains on screen after it was adjusted and " " sign that flashed in the past remains fixed.
It is possible to make time set up between 0-23.59 hours. At the end of cooking period an alarm is
heard and " " symbol flashes. You can press any key to stop the alarm.
Programming as Determining the Cooking Period
interval. To adjust the cooking period, "Mode" key is pressed until "Dur" indicator lamp will start to flash.
The wished cooking period is adjusted by using "+" and "-" keys. Once the time is adjusted it is registered
automatically in 5 seconds following the adjustment and "A" and "" symbols start to light continuously.
The screen returns to the current time. An alarm (sound) is heard when the cooking period ended and
"A" and "" symbols start to flash. Press onto any switch stops the signal and the lamp to flash. It is
possible to adjust cooking period between 0-10 hours.
determining the Finish Time
This function is used to adjust finish time of the cooking period. To adjust the finish time of cooking
"Mode" key is pressed until "End" indicator lamp will start to flash. The wished finish time is adjusted by
using "+" and "-" keys. When the finish time is reached an alarm is heard and you can press any key to
stop the alarm.
Programming as determining the Cooking Period and Finish Time
This function is used to adjust the cooking period by using of automatically cooking function. Both cooking period and ending time
have to be adjusted to adjust the ending of cooking period. The cooking period is adjusted as determined above. "Mode" key was
pressed until "End" indicator lamp will flash in order to adjust the ending time. "+" and "-" keys must be used at the end of wished
cooking period. Once the time is adjusted, it is registered automatically in 5 seconds following the
adjustment and "A" and "" symbols starts to light continuously. The screen returns to the current time.
An alarm sound is heard at the end of the time and "A" symbol starts to flash. Pressing any switch
stops the signal and lamp to flash.
HOW TO OPERATE THE OVEN IN MANUAL MODE
- Turn the oven selector knob to the desired cooking function.
- Turn the thermostat knob clockwise to the required temperature.
At the end of cooking: Turn the knobs to "0".
HOW TO OPERATE THE GAS HOB
USING THE GAS BURNERS
The following symbols appear around each knob.
Shaded circle
Large flame
Small flame
The minimum position is when the knob is turned fully anticlockwise. Control knobs must always be set somewhere between the
min. and max. positions, and never between max. and off.
Adjusting minimum gas setting of taps (if necessary)
To ensure that the minimum setting is correctly adjusted, remove knob and proceed as follows:
tighten (-) to reduce the height of the flame;
The adjustment must be performed with the tap in minimum gas setting position (small flame).
Upon completion of adjustment, reseal using sealing wax or an equivalent material.
The primary air of the burners does not need to be adjusted. After the adjustment of the
minimum gas setting, light up the burners and turn the knobs from max. position to min.
position to check the stability of the flame.
Tap closed
0
Max. flame setting
Min. flame setting
"