Table of Contents
Advertisement
SECTION 2
DRIVING YOUR MOTOR HOME
MULTI-FUNCTION SIGNAL
LEVER
The multi-function signal lever controls the
turn signals, high/low beam changing, wind-
shield washer, wipers and wiper delay, and the
electronic speed control (cruise) on some models.
See your chassis operating guide for complete
operating information.
HEADLIGHT BEAM CHANGE
AND TURN SIGNALS
Move multi-function lever upward for right
turn signal and downward for left turn signal.
Pull end of handle toward you to switch high
beam to low, or low beam to high.
WINDSHIELD WIPERS AND
WIPER DELAY
See your chassis operating guide for complete
operating information.
CRUISE CONTROL
The electronic speed control (cruise) allows
you to maintain a steady speed and relieve driv-
ing strain while traveling long distances.
See your chassis operator manual for com-
plete instructions and precautions on the cruise
control.
WARNING
Do not operate the cruise control on
icy or extremely wet roads, winding
roads, in heavy traffic, or in any other
traffic situation where a constant
speed cannot be maintained.
NOTE: Before leaving on vacation or a long trip,
make a short road test to see that all
functions are working. If your speed
control does not function properly,
contact your dealer.
2-10
COMFORT CONTROLS
AUTO AIR CONDITIONER/
HEATER
Controls for the air conditioner, heater, de-
froster and vent are all combined into one control
panel. Refer to the following instructions for use
of individual controls.
Temp
Fan Switch
Control
1. Front Heater Fan Switch
2. Temperature Control Knob
3. Mode Selection Knob
HEATING
A. For maximum heating
1. Turn the mode selection knob HEAT or
VENT.
2. Turn the temperature control knob to
WARM (red).
3. Place the fan switch to high (largest dot).
B. For reduced heating:
1. Turn the temperature control knob
toward the COOL (blue) zone to the
desired comfort position.
2. Adjust the fan speed for desired volume.
DEFROSTING
A. For maximum defrosting and defogging:
1. Turn the mode control knob to DEF.
2. Turn the temperature control knob to
WARM (red).
3. Turn the fan switch to high (largest dot).
4. Turn on auxiliary (dash) fans if addi-
tional air movement is needed.
Mode
Control
Advertisement
Table of Contents
