Table of Contents
Advertisement
SECTION 2
DRIVING YOUR MOTOR HOME
4. If the slideout room has a couch or other fur-
niture, make sure no people or pets are
seated on them until the room has been fully
retracted.
5. Park Brake must be set.
CAUTION
Although there is an awning over the
roof of the slideout room, there is a
possibility of debris getting onto the
roof. Because the slideout roof is
drawn into the interior of the coach
when retracted, be sure there is no
debris, such as excessive dirt, tree
seeds, twigs, leaves, etc. on the roof
before retracting.
To Retract the Slideout Room
See Operation Safety Precautions before pro-
ceeding.
To retract the room, press and hold the "IN"
button.
· To stop the room during operation, release
the button.
· When the room has retracted completely, it
will stop automatically.
· After the room has been retracted, refasten
the safety travel straps.
TROUBLESHOOTING - Problems Retract-
ing the Room
Set the Park Brake if the red Park Brake light
flashes while pressing the Retract button.
2-18
Green light will flash error code
If an error is detected on your DigiSync Room
Slide System, the green LED on the left side of
the control panel will blink an error code. If an
error code appears, see the On Board diagnostics
section to determine the problem. The error code
must be cleared prior to operating the room. To
clear the error, press the "STOP" button. Before
operating the room after an error has been detect-
ed, check for obvious faults such as obstructions
prior to trying to operate the room again. If the
error code appears again, the room will need to be
retracted using either the semi-manual retraction
method or the fully manual method. Both meth-
ods listed below are intended as a means to
retract the room to prepare the coach for travel to
the nearest authorized Service Center.
To retract the room after an error is detected,
you override the synchronization programming
and operate the room in the Semi-Manual Mode.
Semi-Manual Mode:
Semi-Manual Mode lets you individually
move the two room arms by pressing the IN and
ON buttons on the control pad. This mode can be
used only if there is not a motor failure or full
electrical system failure. To override the
coder and enter the Semi-Manual Mode, press
and hold the STOP button until the two LEDs
begin to flash.
While in the Semi-Manual Mode each of the
two, room slide arms are activated by pressing
and holding the IN and OUT buttons. The "OUT"
button will retract the front arm. The "IN" button
will retract the back arm. Both IN and OUT
buttons may be held down at the same time to
en-
Advertisement
Table of Contents
