MULTI-FUNCTION SIGNAL
LEVER
The multi-function signal lever con-
trols the turn signals, high/low beam changing,
windshield washer, wipers and wiper delay, and
the electronic speed control (cruise) on some
models.
See your chassis operating guide for complete
operating information.
HEADLIGHT BEAM CHANGE
AND TURN SIGNALS
Move multi-function lever upward for right
turn signal and downward for left turn signal.
Pull end of handle toward you to switch high
beam to low, or low beam to high.
WINDSHIELD WIPERS AND
WIPER DELAY
See your chassis operating guide for complete
operating information.
WINDSHIELD WASH/WIPE SWITCH
(Freightliner Chassis)
Wash: Press the control knob to pump washer
solution onto the windshield. The wiper will also
begin operating. The wiper will continue for 5
wipes after you release the washer knob.
Wiper: Rotate the outer knob pointer to the de-
sired setting - Delay, Low or Hi.
Center Knob:
Push for Wash
Turn to Adjust
Wiper Delay
Outer Knob:
Turn to Select
Wiper Speed
DRIVING YOUR MOTOR HOME
Delay: Turn the outer knob pointer to "Delay".
Turn the center (wash) knob to set the time you
want between wipes, from 1 second (all the way
left) to about 90 seconds (all the way right).
HAZARD WARNING LIGHTS
See chassis manual or "Instrument Panels" in
this section for location of hazard flasher switch.
See also Section 3 for further operating informa-
tion.
CRUISE CONTROL
The electronic speed control (cruise) allows
you to maintain a steady speed and relieve driv-
ing strain while traveling long distances.
See your chassis operator manual for com-
plete instructions and precautions on the cruise
control.
WARNING
Do not operate the cruise control on
icy or extremely wet roads, winding
roads, in heavy traffic, or in any other
traffic situation where a constant
speed cannot be maintained.
COMFORT CONTROLS
AUTO AIR CONDITIONER/
HEATER
Controls for the air conditioner, heater, de-
froster and vent are all combined into one control
panel. Refer to the following instructions for use
of individual controls.
Fan Speed
Temp
Control
Control
SECTION 2
Mode
Selector
2-13