Table of Contents
Advertisement
SECTION 2
DRIVING YOUR MOTOR HOME
MULTI-FUNCTION SIGNAL
LEVER
The multi-function signal lever controls the
turn signals, high/low beam changing, wind-
shield washer, wipers and wiper delay, and the
electronic speed control (cruise) on some models.
See your chassis operating guide for complete
operating information.
HEADLIGHT BEAM CHANGE
AND TURN SIGNALS
Move multi-function lever upward for right
turn signal and downward for left turn signal.
Pull end of handle toward you to switch high
beam to low, or low beam to high.
WINDSHIELD WIPERS AND
WIPER DELAY
See your chassis operating guide for complete
operating information.
HAZARD WARNING LIGHTS
The hazard flasher light switch is located on
the upper surface of the steering column. Press
and release button to turn flashers on or off. See
Section 3 and your chassis manual for further
operating information.
2-14
CRUISE CONTROL
The electronic speed control (cruise) allows
you to maintain a steady speed and relieve driv-
ing strain while traveling long distances.
See your chassis operator manual for com-
plete instructions and precautions on the cruise
control.
WARNING
Do not operate the cruise control on
icy or extremely wet roads, winding
roads, in heavy traffic, or in any other
traffic situation where a constant
speed cannot be maintained.
COMFORT CONTROLS
AUTO AIR CONDITIONER/
HEATER
Controls for the air conditioner, heater, de-
froster and vent are all combined into one control
panel. Refer to the following instructions for use
of individual controls.
Fan Speed
Temp
Control
Control
Heating
A. For maximum heating
1. Turn the temperature control knob
toward the COOL (blue) zone to the
desired comfort position.
2. Turn the temperature control knob to
WARM (red).
Mode
Selector
Advertisement
Table of Contents
