Table of Contents
Advertisement
CB RADIO WIRING
(Optional)
If your coach is pre-wired for CB radio instal-
lation, the wires are located in the main wiring
harness beneath the instrument pod. Lift the in-
strument pod as shown to access the wiring har-
ness.
CB Radio Wiring
Look for a pair of wires, purple (+) and green
(-), with flag labels.
Be sure to read the wire labels before install-
ing a CB radio. The labels contain important in-
formation and cautions.
TO
CB RADIO
RED BLK
CB POWER PROVISON
PURPLE
GREEN
COAX
(SEE REVERSE ALSO)
CB ANTENNA
CABLE
SWR Adjustment
To adjust CB antenna SWR (standing wave
ratio), turn the adjusting ring of the antenna to
achieve lowest SWR reading. This procedure
will help optimize transmitting and receiving ca-
pabilities of the CB radio system.
TO
CB RADIO WIRING
LABEL
+12 V
GROUND
ANTENNA
WIRE ASM-IP, MAIN
ELECTRICAL SYSTEMS
CAUTION
The CB radio could become damaged
if the CB antenna SWR is not
adjusted before operating the CB
radio.
TRAILER WIRING CONNECTOR
Your coach is pre-wired for trailer or car tow-
ing lights with a 6-pin socket on the rear bumper.
The connector plug is supplied in the coach parts
package provided to you by your dealer when
you took delivery of the vehicle.
The diagram shows proper connection of trail-
er or tow vehicle wiring to the coach light system.
Remove the small screw near the end of the plug
and slide the contact assembly out of the barrel.
SECTION 6
6-9
Advertisement
Table of Contents
