Table of Contents
Advertisement
SECTION 8
APPLIANCES & INTERIOR FEATURES
CAUTION
Always align directional handle to
"DOWN" position before lowering.
Digital Satellite System Wiring
The roof of your coach is pre-wired with
coaxial cable and elevation sensor wiring for
later installation of a Digital Satellite System
(DSS) if not factory equipped. See your autho-
rized Winnebago Industries dealer for proper
installation of this system and proper sealing of
roof mounted components.
TV SIGNAL AMPLIFIER
NOTE: For coaches without the video control
center option, be sure the TV antenna
amplifier switch is turned OFF while
connected to cable. The antenna amplifi-
er will make the cable TV signal snowy.
To operate amplifier, turn on power switch.
8-12
TV Antenna
Cord Jack
Power On
Indicator
TV jack plates are mounted in various loca-
tions throughout the coach. Some of these wall
plates are not readily visible and may be in one of
the following locations.
· In front overhead TV cabinet, if equipped.
· In the flip-down entertainment tray on the
outside of the coach.
CHECKING PERFORMANCE
The TV signals available to an RV are entirely
dependent on its location in relation to the trans-
mitter. Signals may vary from strong to no usable
signal at all. We recommend that the TV system
be checked out in an area known to have good TV
reception.
To check the antenna amplifier, raise the an-
tenna, select a TV channel and rotate the antenna
for best picture. Then turn off the amplifier pow-
er switch. If the antenna amplifier is working
properly, the TV picture will now be degraded
(snowy). When you turn the switch back on, the
picture should again be sharp.
CABLE TV HOOK-UP
Some models are equipped with external con-
nections for cable television. The connector is lo-
cated in the shoreline cord compartment.
12-Volt
Power Socket
Signal Amp
Power Switch
Advertisement
Table of Contents
