Repeated Playback Of Selection (Loop Playback) - Tascam DR-40 Reference Manual

Repeated Playback of Selection (Loop
Playback)
With this function, you can continuously repeat (loop) the
playback of a selection that you make.
1 While the Home Screen is open when stopped or
playing back, press the PB CONT button to open the
Playback Control screen.
2 Press the PLAY [7] button to start playback, and
press the ENTER/MARK button at the start point of
the section that you want to play repeatedly. This
position is set as IN (start) point. Then,
corresponding point on the playback indicator bar.
3 Press the ENTER/MARK button at the end point of the
section that you want to play repeatedly. This position
is set as OUT (end) point. Then,
corresponding point on the playback indicator bar.
Loop playback of the section between the IN and OUT
points starts.
During loop playback the
Press the PB CONT button to return to the Home Screen
while maintaining the I/O and loop settings effective.
appears at the
appears at the
indicator also appears.
Even after returning to the Home Screen, the
continue to be shown, along with the
shown at the points corresponding to the IN and OUT
points on the playback indicator bar.
NOTE
• The pop-up message of
section between the IN and OUT points is too short. Set
them again. The section should be 1 second or longer.
• Press the ENTER/MARK button again to clear the IN and
OUT points.
• To stop loop playback, press the MENU button when the
Playback Control screen is open. Press the MENU button
again to start loop playback between the set IN and OUT
points.
• You cannot set the IN and OUT points in different files.
• The previous IN and OUT point settings are lost when you
set the IN point on a different file.
• Accurate assignment of IN and OUT points is not always
possible for variable bit rate (VBR) MP3 files.
6 – Playback
and marks
appears if the
I/O Too Short
TASCAM DR-40
icon
77