Tascam DR-40 Release Note

Updates
Always use the most recent firmware for this device.
Please visit the TASCAM web site at http://tascam.com/ to
check for the latest firmware.
New functions
V1.20 additions
The tuner is now easier to use.
When the screen is open, you can press the
TUNER
ENTER/MARK button to reverse the screen orientation,
making it easier to tune using the built-in mic.
V1.10 additions
You can now set the
EXT IN
the left and right channels independently.
If the input selection on the
( or ) is set to
SOURCE EXT IN
can set the input levels of the left and right
EXT IN
channels independently.
When the Home Screen is open, you can use the
(+/–) buttons on the left side panel to adjust the
LEVEL
input level.
Use the following buttons to switch between adjusting
the input levels of the left and right channels.
•
When the
REC MODE
or
DUAL OVERDUB-SEPARATE
[ ] button.
SOLO
•
When the
REC MODE
, use the
OVERDUB-MIX
NOTE
When the item on the
SOURCE
to or
EXT IN INT MIC
the input signal, elements of both left and right channels
will be included in the effect sound, so sound from the
opposite channel will be mixed into the recorded signal.
When the input selection on the
D01163800D
input levels for
screen
REC MODE
, you
EXT INDEP.
INPUT
item is set to ,
STEREO
, use the
1/2
item is set to or
4CH
[ ] button.
3/4 SOLO
screen is set
EFFECT
and an effect is applied to
screen
REC MODE
DR-40
Release Notes
( or
SOURCE EXT IN
input level will be the same for both left and
EXT IN
right channels.
The delay time range when the
item is set to has been expanded.
4CH
The delay time can now be set to a maximum of 150 ms.
The delay time when the
set to can now be set independently for
4CH
left and right channels.
If there are differences in the distances from the sound
source to the
INT MIC
and to the
EXT IN R
for the time lag by treating the
position and then adjusting the
channel delay times.
IN R
The input level setting pull-up menu has
been changed so that its items correspond to
the input source.
V1.02 additions
Right external input channel muting when
recording 4 channels
When the
REC MODE
screen, a new function has been added that allows
MODE
the right external input channel to be muted by setting
the item to
EXT IN EXT IN 1
you to use a mono mic on the left external input channel
with the built-in mics for three-channel recording.
The files created, however, will still be two stereo files with
the right external input channel muted.
NOTE
•
When the
EXT IN
effects cannot be used when recording
•
If you want the left external input channel to be
centered when monitoring, press the MIXER button
during recording or recording standby and set the
channel 3 to (center) on the
PAN C
) is set to
EXT IN 1/2
REC MODE
item is
REC MODE
, to the channel
EXT IN L
channel, you can compensate
as the basic
INT MIC
and
EXT IN L EXT
item is set to on the
4CH REC
. This function allows
item is set to
EXT IN 1
screen.
MIXER
TASCAM DR-40
, the
,
1