Loop Playback (I/O Loop); Adjusting The Playback Speed (Pb Control); Adjusting The Playback Volume - Tascam DR-100 Owner's Manual

7–Playback

Loop playback (I/O LOOP)

You can set an IN point (starting point) and OUT
point (ending point) within a file and play the part
of the file between these points repeatedly.
1 When the Home Screen is open and the track is
playing or paused, press the
position where you want the loop to start to set
the IN point.
2 When the track is playing or paused, press the
key at the position where you want the
I/O LOOP
loop to end to set the OUT point.
3 After setting both the IN and OUT points, loop
playback starts automatically.
4 Press the ( ) key to stop loop playback.
ª
STOP
You can also press the
restart playback from the endpoint.
NOTE
• You cannot set the IN and OUT points in different
files.
• IN and OUT point settings are lost when you select
a different file.
• If you press the I/O LOOP key when IN and OUT
points are already set, their settings will be erased.
• Setting accurate IN and OUT points might not be
possible with Variable Bit Rate (VBR) format MP3
files.
Adjusting the playback speed (PB
CONTROL)
You can adjust the playback speed by up to -50%
or +16% of the original value. When doing so, it
is possible to change the pitch with the speed or
maintain the original pitch.
36
TASCAM DR-100
key at the
I/O LOOP
( ) key to
PLAY/PAUSE ¥/π
1 When the Home Screen is open, press and hold
the key to open the
PB CONTROL
screen.
2 Set the item to
VSA ON
Speed Audition (VSA) is
change even when the speed is changed. When
, the pitch changes with the speed.
OFF
3 Use the item to adjust the playback speed.
SPEED
4 Press the key to return to the Home
HOME
Screen.
5 Press the
PB CONTROL
function ON and OFF.
NOTE
You can also turn PB CONTROL ON and OFF from the
PB CONTROL screen.

Adjusting the playback volume

The volume output from the built-in speaker or
the connector can be adjusted by using the
dial.
OUTPUT
PB CONTROL
or . When Variable
OFF
, pitch does not
ON
key briefly to turn this
/SP