See Installtion of E18 into Existing Units for General Installation Guidance.
This install of the E18 uses Vent Connection Type A..
The Length of 4" Flex needed is 1-15/16" semi-expanded. Secure fl ue adapter top plate to under side of existing fi rebox using 4 self tap-
ing screws.
Secure top plate to fi rebox w/4 screws.
Secure vent slide plate to fl ex pipe with 4
screws
Firesong 220N Firebox
5 - 3/16"
[132mm]
2 1/8"
54mm
Leg Setting / Outer Shell Position
1. Loosen 2 x philips screws on both right and left legs.
2. See above diagram below for required leg setting.
3. Install with supplied phillips screws to prepunched holes and tighten previ-
ous screws that were loosened in Step 1.
4. Keep left side leg loose until outer fi rebox is in position in ZC box - to allow
adjustment of gas line.
Regency
®
E18 Gas Fireplace Insert
E18 Install Specifi cations
E18 Insert
5 1/4"
133mm
C
Firesong 22N faceplate is an outside fi t, if the front metal face
of the 220N is covered with stone or tile - a custom faceplate
8 3/16"
will be required.
208mm
The following measurements of the 220N metal face will be
visible if no stone or tile is covering it. If this metal face is vis-
ible, the standard Faceplate (6161-920) will fi t.
Set to this
hole
Leg heig
1"
(25mm)
Right side shown
INSTALLATION
Firesong 220N
Front Facing measurements
3"
(76mm)
Set to this
hole
3"
(76mm)
Note: this measurement
is above lower area
37