Regency Studio ES105 Instructions For Use & Installation

Led electric fire range with thermostatic remote control

Hide thumbs

Table Of Contents

Quick Links

Download this manual

Studio

LED Electric Fire Range

with Thermostatic Remote Control

Models: ES105, ES135, ES165

Instructions for Use, Installation & Servicing

For use in the US (United States) and CA (Canada)

IMPORTANT

THE HEATER OUTLET GRILLE BECOMES VERY HOT WHILE IN OPERATION. DO NOT COVER THE OUTLET GRILLE OR ANY

PART OF THE APPLIANCE. For use with 120V 60Hz electricity supply only. Please read these instructions carefully before

installation. Failure to follow them could result in serious injury. SAVE THESE INSTRUCTIONS: Leave this manual with

the appliance, they will be needed when maintenance or servicing is required. THIS APPLIANCE MUST BE GROUNDED

920-650

04.20.2023

Table of Contents

Need help?

Do you have a question about the Studio ES105 and is the answer not in the manual?

Questions and answers

Summary of Contents for Regency Studio ES105

Page 1 Studio LED Electric Fire Range with Thermostatic Remote Control Models: ES105, ES135, ES165 Instructions for Use, Installation & Servicing For use in the US (United States) and CA (Canada) IMPORTANT THE HEATER OUTLET GRILLE BECOMES VERY HOT WHILE IN OPERATION. DO NOT COVER THE OUTLET GRILLE OR ANY PART OF THE APPLIANCE.
Page 2: Table Of Contents
Full terms and conditions are detailed in the Warranty Statement When using electrical appliances, basic precautions should always on the Regency website www.regency-fire.com. In the event of any be followed to reduce the risk of fire, electric shock, and injury to conflict of information the wording on the website shall prevail.
Page 3: Operating Instructions
Owner's Information This device complies with Industry Canada licence-exempt USER INSTRUCTIONS RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and ALWAYS check your appliance cord and plug connections with (2) this device must accept any interference, including interference each use! that may cause undesired operation of the device.
Page 4 1m/3.3 feet. Where the electricity supply cable has to pass through a fire place, However Regency recommend: stone surround etc. ensure suitable rubber bushes are fitted at possible wear points.
Page 5 Owner's Information OPERATING INSTRUCTIONS WARNING! Do not operate the appliance if it is REMOTE CONTROL damaged or has malfunctioned. If you suspect the appliance is damaged or has malfunctioned call a qualified service engineer to inspect the The remote control should be left on a flat surface in the appliance, and replace any part of the electrical room where the appliance is installed and away from any system if necessary, before reuse.
Page 6 Owner's Information OPERATING THE APPLIANCE Press the button for 3 seconds or wait 10 seconds to save and exit the week, time and heating temperature setting. - ADVANCED OPERATION DAILY TIMER HEATING Temperature Sensor Convection The following heating periods have been preset, but can be altered if desired: Display 06:00 until 08:00...
Page 7 Owner's Information FLAME COLOUR ADJUSTMENT NORMAL CONTROL MODE Normal Control Mode is the default setting. Press button. There are 3 flame colour options. Press button until the logo is shown There are 5 levels of brightness, including off. Colour Option Brightness Level Press the ‘+’...
Page 8 Owner's Information ADAPTIVE START CONTROL Press until shows. The heater will automatically determine the appropriate time to heat to ensure that it will reach the set-pointed temperature at the set time (up to 45 minutes prior to the set time). ADVANCE MODE The heating state can be advanced to the next period under both the daily and week timer heating mode.
Page 9 Owner's Information Ensure that the handset batteries are new and inserted correctly. OPERATING THE APPLIANCE - TROUBLESHOOTING Dispose of old batteries at an appropriate recycling facility. Battery replacement is recommended after 1 year. BATTERY The Remote requires two 1.5V alkaline AAA batteries. The battery power level is indicated at the top right of the remote Ensure the correct polarity.
Page 10 Owner's Information MAINTENANCE ENSURE THE APPLIANCE IS TURNED OFF BEFORE CLEANING. Wait for at least 10 minutes until the appliance has cooled down. GLASS CLEANING Wipe the glass viewing panel with a damp cloth and buff with a lint free duster. Caution: Do not use abrasive cleaners on the glass panel.
Page 11 INSTALLATION GENERAL SERIAL DECALS TOOLS REQUIRED ES105 A Screwdriver, Level, Saw and Drill will be needed. UNPACKING THE FIREPLACE WARNING! DO NOT use this appliance if any part has been exposed to water. Immediately call a qualified service technician to inspect and to replace any part of the electrical system if necessary.
Page 12 FITTING THE APPLIANCE SERVICING REQUIREMENTS LOCATING THE STUDIO DURING SERVICING OF THIS APPLIANCE IT MAY BE NECESSARY TO CUT CABLE TIES IN ORDER TO Your new Studio may be installed virtually anywhere in your ACCESS AND REMOVE SOME OF THE PARTS. home.
Page 13: Technical Specification
TECHNICAL SPECIFICATION STUDIO ES105 STUDIO ES135 STUDIO ES165 Studio ES105 1500 Watts Studio ES135 1500 Watts Studio ES165 1500 Watts Maximum power consumption: 120V, 13 amp., 60Hz A 1.8m/72" lead with plug is supplied. 2 x Remote control handset battery (AAA).
Page 14 Remove the wire harness & cover plate from the appliance WIRING KITS by removing the two Philip head screws from the side of the appliance as shown below. Disconnect the Molex connector and remove the wire harness & cover plate. The appliance is supplied with a 3 prong plug with a 72"...
Page 15 Locate the 120 VAC power cord which will be in the manual POWER CORD CONVERSION package that accompanied the appliance. Connect the 120 VAC power cord option to the Molex connector on the appliance (blue to blue, yellow to yellow, red to red). IMPORTANT: A 15 AMP, 60Hz circuit is required for 120 VAC installation.
Page 16: Control System Technical Data
CONTROL SYSTEM TECHNICAL DATA MAIN CONTROL BOARD REMOTE RECEIVER BOARD REMOTE CONTROL Hardware RC01-043A03 V0. RF290B V1.2 RF290A-TX V1.3 Software RC01-043A03 V0. RF290C V06.0.HEX Frequency ASK/OOK 433.92MHz GB: Maximum Transmit Power 10mW PACKING CHECKLIST Studio LED Electric Fire Range with Thermostatic Remote Control Models: ES105, ES135, ES165 x2 (AAA) Instructions for Use, Installation &...
Page 17 Note: Measurement (B) does not include height of platform base if raised off the ground. Example 1/2"(13 mm) thick platform base = 21" (533mm) framing height. DIMENSION (mm) 56-3/4" 20-1/2" 7-5/8" Studio ES105 (1141 mm) (520 mm) (193 mm) 56-3/4" 20-1/2" 7-5/8"...
Page 18 Secure appliance to framing with 4 nailing strips using 4 NAILING STRIP INSTALLATION wood screws. Attach 4 nailing strips to appliance using the small black Philip head screws provided. Slide appliance into framing. Electrical connections should be made at this time.
Page 19 PLUGGING POWER CORD TO COMPLETING THE INSTALLATION APPLIANCE The appliance is designed to be used with 1/2 in. (13 mm) wall sheathing materials such as drywall, plywood, wood composites, or The appliance is supplied with a 3 prong plug with a 72" lead which non-combustible materials with the supplied decorative trim.
Page 20 LED Mood Lighting Strip Kit Installation Instructions LED MOOD LIGHTING STRIP KIT INSTALLATION Part Code: 923-385 The appliance can be enhanced by an optional LED Mood Lighting Strip. This comes with 10' (3 m) of LED mood lighting and can be operated using the remote control provided with this appliance.
Page 21 ACCESSING THE FUEL BED Note:The decorative finishing trim & glass will need to be removed as per the steps below prior to installing any media inside the appliance. The following pages will note how to install any of the supplied or optional media.
Page 22 GLASS EMBERS Spread the Glass Embers evenly over the fuel bed. Note: The Ember Logs (See Log Layout) will rest directly on the fuel bed. LOG SET - LOG LAYOUT ES105 ES135 / ES165...
Page 23 OPTIONAL SILVER BIRCH SET For remainder of log install see previous page which will note how to install 2a, 4a, 6a, 8a, 10a, 12a. ES105 ES135 / ES165...
Page 24: Pairing The Remote Control
COMPLETION OF ASSEMBLY PAIRING THE REMOTE CONTROL TO THE APPLIANNCE Once media has been installed follow steps below to reinstall glass & decorative finishing trim. Signal Code The below operations should be carried out before coding when changing to a new remote or the unit cannot be controlled by the remote: The reset button is located on the control panel located on the right-hand side.
Page 25: Maintenance
MAINTENANCE ACCESSING THE FUEL BED REMOVING THE FUEL BED The decorative finishing trim, glass,media will need to be removed in order to do any maintenance inside of the appliance. THIS APPLIANCE MUST ONLY BE SERVICED BY A SUITABLY QUALIFIED PERSON. BEFORE UNDERTAKING ANY WORK ON THE APPLIANCE: SWITCH OFF THE APPLIANCE AND ISOLATE THE POWER SUPPLY ENSURING THERE IS NO POWER TO THE APPLIANCE.
Page 26 REPLACING THE FUEL BED LEDS...
Page 27 REMOVING THE INNER SCREEN...
Page 28 REMOVING THE FLAME EFFECT...
Page 29 REMOVING THE EFFECT SPINDLE...
Page 30 REPLACING THE FLAME EFFECT LEDS...
Page 31 REMOVING THE FLAME EFFECT REMOVING THE RECEIVER MOTOR...
Page 32 REPLACING THE CONTROL REPLACING THE HEATER UNIT...
Page 33 BUTTON BOARD POWER SWITCH...
Page 34: Wiring Diagram
WIRING DIAGRAM COLOUR CODES DESCRIPTION Heater Unit BLUE Thermostat YELLOW Heater WHITE Fan Motor BLACK Plug Connector Incoming AC Supply: 120V 60Hz required BROWN IEC 60320 "C13" Flame Effect Motor GNYE GREEN & YELLOW Optional Led Mood Lighting Button Board Receiver Board Fuel Effect LED Board Flame Effect LED Board...
Page 35: Spare Parts List
SPARE PARTS LIST Studio ES105 Studio ES135 Studio ES165 Description Item No Quantity Item No Quantity Item No Quantity North America Power Cable EL0782 EL0782 EL0782 Remote Handset EL1079 EL1079 EL1079 Flame Effect LED Board EL0865 EL0864 EL0865 Flame Effect LED Board...
Page 36 INFORMATION REQUIREMENT FOR ELECTRIC LOCAL SPACE HEATERS Studio ES105 Model Studio ES135 Studio ES165 Nominal Heat Output P nom 1.5kW HEAT OUTPUT Minimum Heat Output P min 0.75kW Maximum Continuous Heat Output P max, c 1.5kW At Nominal Heat Output el max 12.5W...
Page 37 ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ _____________________________________________________ _____________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________...
Page 38 LIMITED WARRANTY FPI Fireplace Products International Ltd. (for Canadian customers) and Fireplace Products U.S., Inc. (for U.S. customers) (collectively referred to herein as “FPI”) extends this Limited Warranty to the original purchaser of this appliance provided the product remains in the original place of installation. The items covered by this limited warranty and the period of such coverage is set forth in the table below.
Page 39 Product Registration and Customer Support: Thank you for choosing a Regency Fireplace. Regency strives to be a world leader in the design, manufacture, and marketing of hearth products. To provide the best support for your product, we request that you complete a product registration form at http://www.regency-fire.com/Customer-Care/Warranty-Registration.aspx within ninety (90) days...
Page 41 ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ _____________________________________________________ _____________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________...
Page 42 ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ _____________________________________________________ _____________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________...
Page 44 Installer: Please complete the following information Dealer Name & Address: __________________________________________________________________ ______________________________________________________________________________________ Installer: ______________________________________________________________________________ Phone #: ______________________________________________________________________________ Date Installed: __________________________________________________________________________ Serial #:_______________________________________________________________________________ PrintedinCanada Regency is a trademark of FPI Fireplace Products International Ltd. ® © Copyright 2023, FPI Fireplace Products International Ltd. All rights reserved.

This manual is also suitable for:

Studio es135 Studio es165 228-460 228-484 228-541