Regency E18-NG Owners & Installation Manual page 34

INSTALLATION
See Installation of E18 into Existing Units for General Installation Guidance.
This install of the E18 uses Vent Connection Type A.
The Length of 4" Flex needed is 3" semi-expanded. Secure fl ue adapter top plate to under side of existing fi rebox using 4 self taping
screws.
Secure top plate to fi rebox w/4 screws.
Secure vent slide plate to fl ex pipe with 4
screws
1. Loosen 2 x philips screws on both right and left legs.
2. See above diagram below for required leg setting.
3. Install with supplied phillips screws to prepunched holes and tighten previous screws that were loosened in Step 1.
4. Keep left side leg loose until outer fi rebox is in position in ZC box - to allow adjustment of gas line.
34
E18 INSTALL SPECIFICATIONS
Set to this
hole
Right side shown
Regency ® E18 Gas Fireplace Insert
Set to this
hole