Brake Inspection And Repair - Toro Multi Pro 5700-D Service Manual

Brake Inspection and Repair

1
15
14
13
12
1. Brake housing (LH shown)
2. Seal
3. Pull rod
4. Clevis pin
5. Link
Brake Inspection and Repair (Fig. 9)
1. Scrape gasket material (10) from brake housing and
planetary wheel drive mounting surfaces.
2. Remove retaining ring (9).
3. Remove four stationary discs (7) and three rotating
discs (8).
4. Remove three extension springs (12).
5. Remove actuator assembly (3, 4, 5, 6 and 11) and
three balls (13).
Chassis
2 3
4
8
11
6. Hitch pin (2 used)
7. Stationary disc
8. Rotating disc
9. Retaining ring
10. Gasket
5
5
6
7
8
Figure 9
6. Remove seal (2) from brake housing.
7. Wash parts in cleaning solvent. Inspect components
for wear or damage.
8. Reverse steps 2 – 6 to assemble brakes, installing
new parts as necessary. Install a new seal (2).
9. Use a new gasket (10) when installing the brake as-
sembly to machine.
Page 7 – 12
7
9
11. Rotating actuator
12. Extension spring (3 used)
13. Ball (3 used)
14. Plug (2 used)
15. O–ring
Multi Pro 5700–D
10