Toro Multi Pro 5700-D Service Manual page 169

Adjustment
1. Loosen end nut that secures adjustable clevis to
boom frame (Fig. 45). Position jam nut as close as pos-
sible to adjustable clevis. Tighten end nut to secure cle-
vis.
2. Fully raise side boom with the boom actuator. The
boom actuator should fully extend and ratchet.
3. With the boom actuator at full extension, there
should be a gap of approximately .105" (2.7 mm) be-
tween the breakaway pivot gusset and the center boom
frame slot (Fig. 46).
4. If needed, loosen end nut that secures adjustable
clevis and readjust jam nut on clevis to allow correct
boom actuator extension. Tighten end nut to secure cle-
vis adjustment.
Multi Pro 5700–D
1. Boom actuator
2. Adjustable clevis
1. Breakaway pivot gusset
2. Boom frame slot
Page 6 – 43 Rev. A
2
3
1
Figure 45
3. Jam nut
4. End nut
1
2
Figure 46
3. Boom actuator
Spray System
4
3