Boom Actuator (Machines With Serial Numbers Below 260000000) - Toro Multi Pro 5700-D Service Manual

Boom Actuator (Machines with Serial Numbers Below 260000000)

1
2
1. Cotter pin
2. Clevis pin
Removal (Fig 44)
1. Park machine on a level surface, lower booms, stop
engine, engage parking brake, and remove key from the
ignition switch.
2. Label actuator electrical leads to ease reassembly.
Unplug boom actuator connector wires from machine
harness.
3. Support boom to prevent it from falling. Remove cot-
ter pins and clevis pins that attach boom actuator to cen-
ter and side boom.
4. Pull actuator from machine.
Spray System
3
4
1
2
3. Boom actuator
3
Figure 44
Installation (Fig 44)
1. Position actuator to clevis attachment points on cen-
ter and side booms.
2. Install clevis pins and cotter pins to secure actuator
to boom assembly.
3. Plug actuator connector wires into machine harness.
Make sure that operator switches engage correct actua-
tor.
Page 6 – 42
Rev. A
4. Wire harness
Multi Pro 5700–D