Turret Body Service - Toro Multi Pro 5700-D Service Manual

Turret Body Service

Disassembly (Fig. 36)
IMPORTANT: Make sure to remove and neutralize
chemicals from spray components before disas-
sembly. Wear protective clothing, chemical resist-
ant gloves, and eye protection during repair.
1. Pull e–clip from body and slide plug with o–ring from
body.
2. Disassemble turret body using Figure 36 as a guide.
3. Discard all removed seals, gaskets, o–rings, and di-
aphragms.
Assembly (Fig. 36)
NOTE: Coat all o–rings with vegetable oil before instal-
lation to reduce the chance of damage during assembly.
1. Replace all removed seals, gaskets, o–rings, and di-
aphragms.
2. Assemble turret body using Figure 36 as a guide.
A. The turret (item 8) end with slightly larger bore
and detent grooves needs to be orientated toward
detent posts on body (item 4) (Fig. 37).
B. Make sure to align notch on plug (item 10) with
groove in body (item 4) as plug is installed.
C. Install e–clip (item 5) into body to secure assem-
bly.
Multi Pro 5700–D
18
17
16
15
1. Upper clamp
2. O–ring
3. Pivot pin
4. Body
5. E–clip
6. Gasket (3 used)
7. Dust cap (2 used)
8. Turret
9. O–ring
1
2
1. Body
2. Detent post
Page 6 – 37
1
5
2
3
6
4
8
6
13
14
11
12
Figure 36
10. Plug
11. Nozzle
12. Nozzle cap
13. O–ring
14. Seal
15. Screw
16. End cap
17. Diaphragm
18. Hose barb
3
2
Figure 37
3. Detent groove
Spray System
7
9
10