Toro Multi Pro 5700-D Service Manual page 149

IMPORTANT: Make sure to remove and neutralize
chemicals from spray components before disas-
sembly. Wear protective clothing, chemical resist-
ant gloves, and eye protection during repair.
Disassembly (Fig. 22)
1. Separate boom valve motors as needed using Fig-
ures 22 and 23 as guides. Discard all removed o–rings
and gaskets.
2. See Boom and Agitation Valve Motors in this section
for disassembly and assembly information of boom
valve motor.
Assembly (Fig. 22)
NOTE: Coat all o–rings with vegetable oil before instal-
lation to reduce the chance of damage during assembly.
1. Assemble boom valve motor assembly using Fig-
ures 22 and 23as guides. Replace all removed o–rings.
2. Before installing rod (Item 22) into assembly, thread
nut (item 16) fully onto rod end that has fewer threads.
Make sure that o–ring (Item 20) is not damaged during
installation over rod.
3. Install boom valve motor assembly on machine (see
Spray Control Assembly in this section).
4. Operate spray system and check for leaks.
Multi Pro 5700–D
1
7
1. Agitation valve motor
2. LH boom valve motor
3. Center boom valve motor
4. RH boom valve motor
Page 6 – 23
3
2
6
Figure 23
5. RH boom supply hose
6. Center boom supply
7. LH boom supply hose
Spray System
4
5