Master Boom (Foot) Switch - Toro Multi Pro 5700-D Service Manual

Master Boom (Foot) Switch

The master boom switch is located on the floorboard of
the machine (Fig. 29). This switch allows the machine
operator to control the operation of all boom sections us -
ing one switch.
Testing
1. Locate switch and unplug wire harness connectors
from switch. Note wire connector location on switch.
2. The switch terminals are shown in Figure 30. Conti-
nuity should exist between the common terminal and
only one of the side terminals. When the switch is de-
pressed, continuity should exist between the common
terminal and the other side terminal. Regardless of
switch position, there should never be continuity be-
tween the two side terminals.
3. Reconnect the harness connectors to the switch af -
ter testing.
Electrical System
2
1. Common terminal
Page 5 – 18
1
Figure 29
1. Master boom switch
1
2
Figure 30
2. Side terminal
Multi Pro 5700–D