Tourer Rear Vision System; Rear Camera Pod; Rear Vision Screen; Rear View Transmitter - Truma Boiler Manual

Tourer Rear Vision System

When fitted, a rear vision camera will be
present close to the high level brake light
at the rear of the caravan, connected to a
wireless transmitter housed above the number
plate recess.
Fig. 1 Rear camera pod
Power
button
Pair button
Fig. 2 Rear vision screen
Pair button
Fig. 3 Rear view transmitter
Supplied separately, a screen with power sup-
ply leads, and a windscreen mount, is to be
used in the towing vehicle to receive pictures
from the transmitter. The screen has an internal
re-chargeable battery, allowing short term
TOU R ER RE A R V IEW CA ME R A
use without a power supply lead. For longer
journeys, or to re-charge the internal battery,
please use the power leads provided.
The camera and transmitter will be operational
when the towing vehicle is connected (via
the 13-pin towing lead), and the tow vehicle
engine is running. When the screen is then
turned on, via an extended press of the power
button on the top of the unit, images from
the camera / transmitter will automatically be
displayed. Press and hold the power button
again to switch the screen off.
If an image is not displayed, please check
the following:
• The screen has two input channels. While
the screen is ON, short presses of the power
button will alternate the display between
these channels. Check the alternate channel
for an image.
• The transmitter and receiver need to be
paired, to communicate with each other.
This should have been done by the
supplying dealer, but if the settings have
been lost please repeat the procedure
described below.
Pairing the transmitter and screen
• Ensure that the screen has sufficient charge
for use without a power lead.
• Connect the tow vehicle and start the
engine. Ensure you have an assistant with
you who can stay in the car while the engine
is running, for both safety and security
reasons.
• On the screen, find the recessed pairing
button as shown in the image on this page.
(Fig. 2)
• At the rear of the caravan, locate the
rectangular plate housed between the
number plate lights, and find the pairing
button as shown in the image on this page.
(Fig. 3)
• Turn the screen on. Using a small diameter
item such as a paper clip, press the pair
button on the screen unit. A message
'PAIRING START' or similar will be displayed.
(Fig. 2)
185