Caravans With External Barbeque Point - Truma Boiler Manual

EX TER N AL B BQ P OI N T
2. Components replaced during repair under
guarantee become the property of Thetford.
3. This warranty does not prejudice current
consumer protection laws.
4. This warranty is not valid in the case of
products that are for, or are used for,
commercial purposes.
Guarantee claims falling into one of the
following categories will not be accepted:
• the product has been improperly used or
the instructions in the manual have been
followed (for example incorrect use of
additives;
• alterations have been made to the product;
• the product has been repaired by an
unauthorised Thetford Service Centre;
• the product code or serial ID has been
changed;
• the product has been damaged by
circumstances outside the normal use of the
product.
5. Not using Thetford products to care for
your Thetford toilet could create some
damage, which would not be covered by
this warranty.
Thetford is not liable for any loss and/or
damage caused directly or indirectly by use of
the toilet.
Caravans with external
barbeque point
Models equipped with an external barbeque
point can be used to power any gas appliance
suitable for the gas used in the caravan, at the
working pressure shown on the label in the
barbeque outlet box. Please note when using
the outlet that the fitted regulator will allow a
maximum of 1.5kg per hour of gas to be taken
from the gas bottle. Therefore the consumption
of gas from both the appliances within the
caravan and the appliance connected to the
barbeque point cannot exceed a total of 1.5kg
per hour at any one time. If you are in any
doubt please consult your dealer for advice. To
use point proceed as follows:
172
When external gas equipment is being
connected, the operating pressure of the gas
supply of 30 or 50 mbar must correspond with
the operating pressure of he equipment that is
being connected (see data plate).
The plug-in connection can only be made if the
quick acting valve is closed. The safety locking
mechanism can be released by sliding back
the coupling sleeve.