Use Of Your Toilet; Emptying The Tank; Turning The Bowl; Opening The Blade - Truma Boiler Manual

Use of your toilet

Turning the bowl

You can turn this bowl to a
desired position (max. ±90°C).
Close the cover and use both
hands to rotate the bowl as
illustrated.

Opening the blade

The toilet can be used with
the blade open or closed.
To open the blade, slide the
blade sideways as illustrated.
Make sure you always close
the blade completely after use.
Electric blade (if applicable)
Press the flush button to activate the control
panel. Then push the Electric blade button.
The blade will open or close electrically.
Flushing the toilet
Press the flush button once
to activate the control panel.
Then press the flush button
for several seconds to flush
the toilet.
Electric ventilator (if applicable)
By activating the control panel, the Electric
ventilator start automatically. The button
will flash to indicate this function is active.
To stop the Electric ventilator, press the
button. Press the button again to restore
the Electic ventilator. To optimise its function,
activate the Electric ventilator before use of
your toilet.
Note: Even without an own flush water tank
you can still use Aqua Rinse for a smooth
and fresh lavender scented flush. Simply
spray Aqua Rinse with a spray can evenly
into the toilet bowl before use.
Note: Ordinary toilet paper can cause
clogging. Use Aqua Soft toilet paper instead.
This toilet paper is super soft, dissolves
quickly, prevents clogging and makes it
easier to empty the waste holding tank.
Level indication
You can check whether your waste holding
tank has a 1 level or a 3 level indication. Make
sure the tank is empty and place it properly.
Then activate the control panel. If no level
indication light lights up, your toilet has a 1
level indication. It will only indicate a full tank. If
a green level indication light immediately lights
up, your toilet has a 3 level indication. It will
indicate empty, half full and full.

Emptying the tank

Waste holding tank
When the red light of the level indicator on the
control panel lights up, you need to empty
the waste holding tank. Remove the tank via
the service door. Then take it to an authorised
waste disposal point. Empty the waste holding
tank via the pour out spout.
!
WARNING: Do not lift the coupling head
by hand when hitching the caravan to the
car. Always raise and lower the coupling
head by winding the handle on the jockey
wheel up and down.
Waste pump out system (if applicable)
By activating the control panel, this button
automatically lights up. Press the button
to empty the waste holding tank into the
vehicle's central waste tank. The button
flashes while the waste is being pumped
and stops flashing when all waste has been
transferred. (±1.5L of waste is left). If the
central waste tank is too full (only measured
when this tank has a level indicator), the
button flashes rapidly and no pump out is
possible until you have emptied the central
waste tank.
169