Removing The Antenna - Truma Boiler Manual

STATUS 550 DIRECTIONAL
TV AND FM RADIO ANTENNA
(model dependant )
Firstly determine the approximate location
of the nearest transmitter and whether the
signals are horizontally or vertically polarized.
For assistance ask your site operator or check
antennas in the vicinity
1. Loosen the Mast Locking Collar and Wall
Bracket and raise the antenna. Turn the
mast to direct the Antenna towards the
TV transmitter.
The RED spot on the bottom of the mast
indicates the front of the Antenna.
2. When receiving vertically polarized signals,
rotate the winder anti-clockwise to cant
the antenna through 90°. The red / green
indicator, if present, indicates vertical or
horizontal orientation.
Note: DO NOT over tighten or use undue
force on the winder.
3. Switch ON the Power Pack and the RED
LED will illuminate.
4. Check the gain control switch is set to
normal – NML.
5. Tune your television to the strongest signal.
You may need to adjust the direction of the
mast to achieve the best quality picture.
6. Secure by tightening the Mast Locking
Collar and Wall Bracket

Removing the antenna

A permanently fitted Status can be easily
removed leaving only the Mounting Foot and
rubber gaiter.
1. Unplug the antenna from the Power Pack.
2. Loosen the Mast Locking Collar and
Wall Bracket and lift off whilst feeding out
the cable.
3. Push the Blanking Cap supplied into place.
!
WARNING: The Blanking Cap is a
temporary seal and is not for long term use.
STATU S 5 50 DIRE CT ION A L T V
AN D F M RA DIO A NT E N NA
!
WARNING: Always ensure the aerial is
lowered before driving off.
175