Assembling - Nordpeis N-24 round Installation & User Manual

5. Assembling N-21/N-24
The following tools are necessary:
• 13-mm. spanner
• Drill / screwdriver for crosshead screws
• Caulking gun
• Possibly a hammer
1. First you should run an inventory on all loose parts, and it should contain the following parts (look
at figure 1 (N-21) and figure 2 (N-24):
A. 3 legs and 3 adjusting screws with set nut
B. 3 screws with discs
C. 1 smoke dome part 1
D. 1 smoke dome part 2
E. 1 small clamp strap with 2 adjusting screws
F. 1 large clamp strap with 2 adjusting screws
G. 1 heat shield for the back of inset
H. 1 heat shield with self-drilling screws, for smoke dome
I. 1 heat shield for the combustion air vent
J. 1 cartridge with furnace cement
K. 1 fire inset with door and vermiculite heat insulation plates inside
L. 1 loose grip for air regulator handle
N-21 flat
D
B
G
I
K
A
A
H
IMPORTANT! Be careful when touching the fire insert during it's first firings as the paint will
be very soft until it has cured. It can take several firings to cure the paint.
C
E
J
F
A
Glove and lighter comes with the insert
D
G
I
K
A
Figure 1
N-24 round
C
B
E
J
F
A
H A
Figure 2
9