Standard Dmd1050 Factory Configuration Settings - Comtech EF Data Radyne DMD1050 Installation And Operation Manual

DMD1050 Satellite Modem Board

2.5.1 Standard DMD1050 Factory Configuration Settings

Implementing Strap Code 26 can set the following modem configuration.
Refer to Table 4-4 for an explanation and tabular listing of available Strap
Codes. The Frequency and Modulator Output Power are set independently of
IMPORTANT
the strap code.
Modulator:
Data Rate:
Mode:
Satellite Framing:
Scrambler:
Inner FEC:
Outer FEC:
Modulation:
Frequency:
Modulator Output Power:
Demodulator:
Data Rate:
Mode:
Satellite Framing:
Scrambler:
Inner FEC:
Outer FEC:
Modulation:
Frequency:
To lock up the modem, enter 'IF Loopback Enable' under the Test Menu, or connect a Loopback
Cable from TX port to RX port.
Using the modem's loopback capabilities with the Ethernet data interface can cause
undesirable network loops. Before you do any data test with an Ethernet interface,
make sure to use two modems connected back-to-back. If you use one modem and a
IMPORTANT
loopback, the results will not be as desired.
MN-DMD1050
Revision 9
2.048 Mbps
Closed Network
None
V.35 (IESS)
1/2 Rate Viterbi
Disabled
QPSK
950 MHz
-20 dBm
2.048 Mbps
Closed Network
None
V.35 (IESS)
1/2 Rate Viterbi
Disabled
QPSK
950 MHz
Installation
2–3