Canceling Demonstration Mode - Comtech EF Data Radyne DMD1050 Installation And Operation Manual

DMD1050 Satellite Modem Board
a.
b.
The value displayed on the top line of this menu is the 12-digit Unit ID. It is displayed as 3
sets of 4 digits in a dot-delineated format as follows:
1 2 3 4 . 1 2 3 4 . 1 2 3 4
Your Sales Representative will ask you for this number along with the features you wish to
demo.
3. Once your order has been processed, you will be issued a 12-digit demonstration code. This
code can only be used one time and it is only good on the modem for which it was originally
requested. To enter this code, do the following:
a. From the "Enter Selection Number" line type in 45.
b. Press Enter.
c. Enter the new code and press "Enter"
d. Your system is now upgraded.
If the code entered is correct, the display will display CODE ACCEPTED, otherwise the
display will read INVALID CODE
Care should be taken to insure that the demonstration code is entered properly. After
three unsuccessful attempts to enter a code, the upgrade and demonstration capability
will be locked out and it will be necessary to cycle power on the modem in order to
IMPORTANT
continue.
H.6

Canceling Demonstration Mode

At any time, a demonstration may be canceled and have the modem return to its normal
operation. Once the demonstration has been canceled, it cannot be restarted using the old
demonstration code. In order to restart a demonstration, it will be necessary to obtain a new
demonstration code.
To cancel a demonstration from the Terminal Port, perform the following:
1. From the Terminal Main Menu, type in 19 (Features) and press "Enter".
2. From the "Enter Selection Number" line type in 45.
3. Press <ENTER>.
4. Using the numeric keypad, enter 0000 0000 0000
5. Press < ENTER>.
The modem will immediately terminate the demonstration and the feature set will revert back to
the permanent configuration.
The Mod and Demod Test LED's will stop flashing.
MN-DMD1050
Revision 9
From the main menu, the Features menu.
"Feature Id: is the unit ID number
Software Upgrade Procedure
H–3