Table of Contents
Advertisement
DMD1050 Satellite Modem Board
Interface / RX Setup Menu
Circuit ID:
Terrestrial Streaming:
Terrestrial Interface:
BUFFER CLOCK CONTROL
Buffer Size (msec):
Buffer Clock Polarity:
Number of Buffer Sources:
Active Buffer Clock:
MN-DMD1050
Revision 9
Figure 7-17. Interface / RX Setup Menu
Provides entry of Rx Circuit Identifier. Circuits can be given up
to an 11 Character alphanumeric Identity such as DLINK1
{BYTE OUTPUT, PACKET OUTPUT} ASI only
Byte output = continuous
Packet output = burst
{ETHERNET, MIL-188-114A}
Allows the user to select the Receive Type.
{0 - 64 msecs}
Allows the user to set the Doppler Buffer Size in msec.
{NORMAL, INVERTED}
Allows the user to select the Buffer Clock Polarity for the Tx
Terrestrial Clock relative to the Tx Data. If G.703 Interface is
selected, this selection cannot be changed.
{1 – 5}
Allows the user to select up to 5 clock sources.
{RXSAT, EXTBNC, SCTE, SCT, EXT IDI}
Shows the current active buffer clock source.
Web Browser
7–30
Advertisement
Table of Contents
