Table of Contents
Advertisement
Appendix C. TCP/IP Ethernet
C.1
Introduction
The modem supports SNMP, FTP protocols and the Web Browser. Utilization of the protocols is
dependent upon proper set up of the TCP-IP menus. This document is to be used only as a
guideline for setting up the TCP-IP menus. Contact the IT manager for proper guidance to ensure
setup is successful. For additional information on the various WEB or SNMP configurations and
descriptions refer to the Remote Protocol Manual (TM117).
C.2
TCP/IP Network Configuration
Using the Front Panel display and arrow keys, scroll thru the System menu until the TCP / IP sub
menu is displayed. Each unit requires proper configuration with the correct network settings.
Contact the IT manager for a valid IP address mask, Modem, server and router IP addresses.
Enter into the TCP / IP menu and the following Sub menus will appear, however the order may
vary.
1. Boot Mode: This allows for the selection of the operating boot mode for the TCP / IP. Several
selections are available and are described below. When configuring the modem for Web
Browser, Boot Mode must be set to "NON-VOL". A brief description of the available selections
are:
a. Default: If the Ethernet interface is not to be used, select this mode. No IP Address or
mask changes will be allowed while in this mode of operation. The following parameters
will be set and will not change until the boot mode is changed. The IP addresses are non
accessible addresses.
b. BOOTp: When enabled, at boot time, the modem will use the Bootp Protocol to
automatically get names, masks, and IP Addresses of the modem, router, and server from
the Network Manager. This should be consistent with the tag expected by the users
MN-DMD1050
Revision 9
•
IP MASK
•
MODEM IP ADDR
•
SERVER IP ADDR
•
ROUTER IP ADDR
255.000.000.000
010.000.000.001
010.001.001.001
010.000.001.001
Setup
C–1
Advertisement
Table of Contents
