Table of Contents
Advertisement
DMD1050 Satellite Modem Board
MAXIMUM TX POWER
TARGET Eb/No
MN-DMD1050
Revision 9
EFDATA AUPC: When configured for EFDATA AUPC the
minimum Transmit Power is the lowest power setting that will
be used when the local modem commands a decrease of the
Transmit Power from the Remote modem.
RADYNE: When configured for Radyne AUPC, the minimum
Transmit Power is the lowest power setting that will be used
when the remote modem commands a decrease of the Transmit
Power from the Local modem.
NEARSIDE: When configured for NEARSIDE AUPC the
minimum Transmit Power is the lowest power setting that will
be used by the local modem when the Eb/No increases above the
Eb/No target.
{0 to -25 dB}
This allows the user to set the maximum Transmit Power.
EF AUPC: When configured for EF AUPC, the maximum
Transmit Power is the highest power setting that the local
modem will use when the local modem commands an increase in
Transmit power from the Remote modem.
RADYNE: When configured for Radyne AUPC, the maximum
Transmit Power is the highest power setting that will be used
when the remote modem commands an increase of the Transmit
Power from the Local modem
NEARSIDE: When configured for NEARSIDE AUPC the
maximum Transmit Power is the highest power setting that will
be used by the local modem when the Eb/No decreases below
the Eb/No target.
{4.0 to 16 dB}
This allows the user to set the desired E
receiver.
RADYNE AUPC: When configured for Radyne AUPC, this
setting is compared against the remote E
the local modem to increase or decrease the local transmit
power.
EF AUPC: When configured for EF AUPC, this setting is
compared against the local received E
remote modem to increase or decrease transmit power.
NEARSIDE: When configured for NEARSIDE AUPC, this
setting is compared against the received E
modem and commands to the local modem to increase or
decrease transmit power.
Web Browser
/N
for the local
b
o
/N
and commands to
b
o
/N
and commands to the
b
o
/N
of the local
b
o
7–20
Advertisement
Table of Contents
