General Maintenance - Agria 5900 Bison Operating Instructions Manual

5. Maintenance
Twist-grip shift
Check for proper operation and adjustment when perfor-
ming maintenance and adjust, if necessary
Setting
Set the twist-grip shift on the Bowden cable adjustment screw
so there is no play, so that the marking point on the twist-grip
Castellated nut
matches the 0 position of the pump and the pictograph.
Twist-grip locking lever
Setting the clamp
Loosen threaded rod about 1 revolution with hex key
Set locking lever so that:
= twist-grip can turn
= twist-grip is clamped, cannot turn

General Maintenance

Every time You take up operation watch out for fuel and
A
oil leakage, repair if necessary.
Regularly check bolts and nuts for tight fit, re-tighten, if
5
necessary.
At least once a year and after cleaning: Slightly grease
all gliding and moving parts (e.g. speed control lever, lever
bearing, etc.) with bio-lubricating grease and bio-lubrica-
tion oil.
Cleaning
After each cleaning (spraying with water, especially with air-
compressed water jets) lubricate all lubrication points, oil
and let tool carrier run for a short time to press water out.
Apply grease generously to leave a grease ring around
bearings to prevent water, plant sap, and dirt from penetrat-
ing.
Clean engine only with a cloth. Avoid spraying with air-
compressed water jets, as water might leak into ignition and
fuel system causing malfunctions.
40 Hydrostatic Tool Carrier Bison