Sym MB10A7-A series Service Manual page 46

Simpo PDF Merge and Split Unregistered Version - http://www.simpopdf.com
Headlight Adjustment
Start the engine, turn on the headlight.
Loosen the headlight lock bolt, move the
headlight upward or downward to adjust the
headlight beam height.
When the proper headlight beam height is
reached, tighten the lock bolt.
Caution
The factory setting of the beam height is
consistent with government orders.
Improper headlight beam setting will
make driver in the opposite lane dazzled
and cause danger.
Brake Switch
Brake switch inspection
When the brake lever is pulled, the brake
switch will light up the brake lamp.
Make sure that electrical starter can be
activated only under braking condition.
Rear brake switch adjustment
Turn on the main switch.
When the brake pedal is stepped down for
20mm，the brake lamp should be activated.
If the brake lamp is not activated or activated
too early, adjust through the rear brake switch
adjusting nut.
Turning clockwise will decrease the free play,
and counterclockwise to increase the free
play.
Nuts, Bolts Tightness
Apply periodical maintenance in according
with the Periodical Maintenance Schedule.
Check if all the bolts and nuts on the frame
are tightened well.
Check all fixing pins, snap rings, hose (pipe)
clamps, and wire holders for security.
To this chapter contents
2. Maintenance Information
Headlight lock bolt
Rear brake switch adjusting nut
Brake switch
2-17