Sym MB10A7-A series Service Manual page 172

To this chapter contents
11. Rear Wheel / Rear Suspension / Rear Brake
Simpo PDF Merge and Split Unregistered Version - http://www.simpopdf.com
Rear wheel installation
Raised part Location groove
Install the rear brake penal into the wheel hub.
Align the location grooves on the rear wheel
dampers with the raised parts on the final
driven flange.
Install the rear wheel.
Rear axle locknut
Final driven flange locknut
Install the rear axle distance collar and insert
the rear wheel axle.
Adjust the drive chain slack.
Tighten the final driven flange locknut.
Torque value：5.0~6.0kgf-m
Fix the rear wheel axle and tighten the rear
axle locknut.
Torque value：6.0~7.0kgf-m
Adjuster nut
Tighten the adjuster nut slightly to prevent it
from loosening.
Install the rear brake torque link.
Install the split pin.
Torque value：1.5~2.5kgf-m
1 lock nut / split
Install the rear brake rod, brake rod spring and
adjusting nut.
Adjust the rear brake pedal clearance.
Rear brake pedal clearance：20~30mm
20~30mm
11-7