Service Precautions - Sym MB10A7-A series Service Manual

Simpo PDF Merge and Split Unregistered Version - http://www.simpopdf.com

Service Precautions

Always use with SANYANG genuine parts and
recommended oils. Using non-genuine parts for
SANYANG vehicle may damage it.
Special tools are designed for remove and install
of components without damaging the part. Using
wrong tools may result in damage.
When servicing this bike, use only metric tools.
Metric bolts, nuts, using wrong tools and
fasteners may damage this vehicle.
Clean the outside of the parts or the cover before
removing it from the bike. Otherwise, dirt and
deposit accumulated on the part's surface may
fall into the engine, chassis, or brake system,
and cause damage.
Wash and clean parts with high ignition point
solvent, and blow-dry with compressed air. Pay
special attention to O-rings or oil seals because
most cleaning agents have an adverse effect on
them.
To this chapter contents
Never bend or twist a control cable to prevent
unsmooth control and premature worn out.
Rubber parts may become deteriorated when old,
and easy to be damaged by solvent and oil.
Check these parts before installation to make
sure that they are in good condition, replace if
necessary.
When loosening a component, which has
different sized fasteners, operate with a diagonal
pattern and work from inside out. Loosen the
small fasteners first. If the bigger ones are
loosen first, small fasteners may receive too
much stress.
Store complex components such as transmission
parts in the proper assemble order and tie them
together with a wire for ease of installation later.
Note the reassemble position of the important
components before disassembling them to
ensure they will be reassembled in correct
dimensions (depth, distance or position).
Components not to be reused should be replaced
when disassembled including gaskets metal seal
rings, O-rings, oil seals, snap rings, and split
pins.
1. General Information
1-3