Sym MB10A7-A series Service Manual page 199

To this chapter contents
12. Electrical System
Simpo PDF Merge and Split Unregistered Version - http://www.simpopdf.com
Winker bulb replacement
1 screw
Remove the winker lens lock screw.
Pull out the hook and remove the winker lens.
Hook
Rubber seal
Press the winker bulb slightly and rotate it
clockwise.
Pull out the bulb and replace it if necessary.
Specification：
Winker bulb 12V 10W
Installation
Install in the reverse order of removal.
Winker bulb can also be replaced with the
reflector be pulled out.
Caution
Make sure winker lens and base properly
sealed up during assembly.
12-18