Sym MB10A7-A series Service Manual page 196

Simpo PDF Merge and Split Unregistered Version - http://www.simpopdf.com
Starter motor removal
Disconnect the starter motor wire.
Remove the starter motor (2 lock bolts).
Starter motor inspection
Connect the battery positive terminal and
starter motor power terminal.
Put up iron between the battery negative
terminal and starter motor case.
Check the starter motor rotating condition.
Replace the starter motor if the rotating speed
is too slow.
Starter motor installation
Install in the reverse order of removal.
Caution
Make sure the O ring is ok and coat it
with motor oil before installation.
To this chapter contents
O ring
12. Electrical System
1 nut
2 bolts
12-15