Buell 2007 LIGHTNING Service Manual page 449

HOME
ADJUSTING SCREW DISASSEM-
BLY/ASSEMBLY
1. See Figure 6-15. Remove adjusting screw assembly.
a. Remove large retaining ring.
b. Remove adjusting screw assembly from pressure
plate.
2. If necessary, disassemble adjusting screw assembly.
a. Remove and discard small retaining ring (6).
b. Separate the adjusting screw (8) from the bearing
(7) and release plate (5).
c. Remove bearing (7) from release plate (5).
7
8
9
1. Retaining ring
2. Spring seat
3. Diaphragm Spring
4. Retaining ring
5. Release plate
6. Retaining ring
7. Bearing
8. Adjusting screw
9. Pressure plate
Figure 6-15. Adjusting Screw Assembly
3. Replace components as required and reassemble
adjusting screw assembly in reverse order.
4. Install adjusting screw assembly into pressure plate.
a. See Figure 6-37.
release plate with corresponding recesses (3) in
pressure plate.
b. Secure the adjusting screw assembly with new
retaining ring.
6-12 2007 Buell Lightning: Drive/Transmission
b1062x6x
5
6
3
4
2
1
Align two tabs on perimeter of
6251
1
3
1. Retaining ring
2. Bearing and release plate
3. Retaining ring
4. Adjusting screw
Figure 6-16. Adjusting Screw Assembly
2
4