Buell 2007 LIGHTNING Service Manual page 214

HOME
Cylinder Head Assemblies
NOTE
See Figure 3-59. Distortion to the head, cylinder and crank-
case studs may result if head screws are not loosened (or
tightened) gradually in the sequence shown.
1. See Figure 3-59. Loosen each head screw 1/8-turn fol-
lowing the sequence shown.
a. Continue loosening in 1/8-turn increments until
screws are loose. Remove head screws.
b. Remove cylinder head, head gasket, and o-rings.
2. Discard head gasket.
3. See Figure 3-56. Remove push rod cover, gasket and
valve tappets.
DISASSEMBLY
1. See Figure 3-60. Clamp VALVE SPRING COMPRES-
SOR TOOL (Part No. HD-34736B) in vise.
2. See Figure 3-60. Compress valve spring with VALVE
SPRING COMPRESSOR.
3. See Figure 3-61. Remove valve keepers, upper collar
and valve spring. Mark valve keepers for reassembly in
their original locations.
4. Use a fine tooth file to remove any burrs on the valve
stem at the keeper groove.
5. Mark valve to ensure that it will be reassembled in the
same head. Remove valve, valve stem seal and lower
collar assembly by hand. No special tools are required to
remove valve stem seal and lower collar assembly.
6. Repeat the above procedure for the other valves.
x0128x3a
Front Cylinder
1st
2nd
Rear Cylinder
2nd
1st
Figure 3-59. Head Screw Loosening/Tightening Sequence
8684
Figure 3-60. Valve Spring Compressor
(Part No. HD-34736B)
2007 Buell Lightning: Engine
3rd
4th
4th
3rd
3-45