Buell 2007 LIGHTNING Service Manual page 197

HOME
8723a
Figure 3-30. Rear Isolator and Mounting Hardware
40. See Figure 3-30. If the crankcases are being separated it
will be necessary to remove rear isolator assembly by
removing the forward two fasteners first and then the two
rear fasteners (re-install with new fasteners).
8728
Figure 3-31. Securing Vehicle for Relocation (Typical)
41. See Figure 3-31. Place a block of wood between rear
isolator mount on main frame and swingarm/oil tank.
42. Route a ratcheting tie down through the swingarm bear-
ings, up over the main frame, through the top stabilizer
area, back down to the ratchet mechanism and secure
swingarm to main frame.
3-28 2007 Buell Lightning: Engine
NOTE
See Figure 3-32. This allows the vehicle to remain together
as a rolling chassis and to be removed from the lift and stored
if necessary.
43. Remove support from under swingarm/oil tank.
44. Remove overhead support.
8726
Figure 3-32. Rolling Chassis (Typical)