Ignition Coil - Buell 2007 LIGHTNING Service Manual

HOME

IGNITION COIL

REMOVAL
1 1
WARNING WARNING
To prevent accidental vehicle start-up, which could
cause death or serious injury, disconnect negative (-)
battery cable before proceeding. (00048a)
1. Disconnect negative battery cable.
2. Remove intake cover assembly. See
COVER ASSEMBLY.
3. Remove air cleaner assembly. See
ASSEMBLY.
4. See Figure 4-77. Disconnect the spark plug cables from
the coil plug posts (1, 5).
5. Detach connector (3) [83].
6. Remove coil fasteners (2).
INSTALLATION
NOTE
To ease installation, install spark plug cables to ignition coil
first.
1. Connect spark plug cables to ignition coil.
2. See Figure 4-77. Attach coil to frame with fasteners (2).
Tighten to 120-144 in-lbs (13.6-16.3 Nm).
3. Attach front and rear spark plug cables to ignition coil
posts.
4. Attach connector (3) [83].
5. Install air cleaner assembly. See
ASSEMBLY.
6. Install intake cover assembly. See
ASSEMBLY.
7. Connect negative battery cable.
2.38 INTAKE
4.44 AIR CLEANER
1.
2.
3.
4.
5.
b0993x4x
4.44 AIR CLEANER
2.38 INTAKE COVER
8843
1
2
Front cylinder post
Fasteners
Coil connector [83]
Coil
Rear cylinder post
Figure 4-77. Ignition Coil Location
2
1
1. Rear Cylinder Post
2. Coil Pin A (rear cylinder)
3. Coil Pin B (12 VDC)
4. Coil Pin C (front cylinder)
5. Front Cylinder Post
Figure 4-78. Ignition Coil
2007 Buell Lightning: Fuel System
4.32
3
4
5
3 4
5
4-99