Buell 2007 LIGHTNING Service Manual page 186

HOME
10646a
1. Fuel line connection
2. Connection for throttle position sensor [88]
3. Connections for fuel injectors [84 & 85]
NOTE
Remove shop towel from entrance of throttle body to ensure
proper operation of induction module.
13. See Figure 3-12. Connect throttle position sensor (2)
[88].
14. Connect fuel injector leads (3) [84 & 85].
15. Connect fuel line (1).
16. Install throttle body velocity stack.
17. Install air filter base plate. See
ASSEMBLY.
18. Install muffler. See 2.32 EXHAUST
NOTE
To remove and install the interactive exhaust system, see
INTERACTIVE EXHAUST SYSTEM.
19. Install intake cover. See
BLY.
20. Install rear belt and idler pulley. See
SYSTEM.
21. Install left side rider footrest and support plate. See
FOOTPEG, HEEL GUARD AND
22. Install sprocket cover. See
23. Install chin fairing. See 2.37 CHIN FAIRING.
24. Install air scoops, right and left sides. See
SCOOPS.
25. Connect fuel pump. See4.39 FUEL
Figure 3-12. Fuel Line and DDFI Electrical Connections (Typical)
4.44 AIR CLEANER
SYSTEM.
2.38 INTAKE COVER ASSEM-
6.6 DRIVE BELT
2.33
MOUNT.
2.34 SPROCKET COVER.
2.39 AIR
PUMP.
2
The connection for fuel pump is just above the pump located
at the rear of the fuel tank on the left side of the vehicle.
Connect positive (+) battery cable first. If positive (+)
cable should contact ground with negative (-) cable con-
nected, the resulting sparks can cause a battery explo-
sion, which could result in death or serious injury.
(00068a)
26. Connect negative ground cable to battery and tighten
fastener to 72-96 in-lbs (8-11 Nm).
7.6
After installing seat, pull upward on front of seat to be
sure it is in locked position. While riding, a loose seat can
shift causing loss of control, which could result in death
or serious injury. (00070a)
27. Install seat. See
3
1
NOTE
11 1
WARNING WARNING
11 1
WARNING WARNING
2.44 SEAT.
2007 Buell Lightning: Engine 3-17