Select Type; Setting Display Types And Groups - Raymarine ST70+ Installation Manual

22

Select type

Scroll to select the vessel type that most closely corresponds to your vessel.
When you have chosen the vessel type, press
to confirm the choice. The Time and Date values
and the data Units considered most appropriate for
the Language and Vessel Type you chose, are then
automatically applied to your ST70+ system and an
automatic check of system parameters is carried
out. On completion, a System configuration page is
present all displays in the system.

Setting display types and groups

You must now:
• Select the display you want to set up.
• Set the display type for each display (Instrument or Pilot Controller).
• Allocate each display to a group.
• Set the sequence number of each display within the group.
• Link at least one keypad to each group.
To do this:
1. With the System configuration page displayed,
OK
press
page.
For unassigned displays (e.g. at first switch
on), the legends Group and Number are dis-
played. If the selected display has already
been set up, this shows the current group and
number in the group for the selected display.
2. Use the Select Display button as necessary, to
move the screen highlight to the display you want to set up, i. e. so it is the selected
display.
OK
3. Press
page.
4. Scroll to select either Instrument or Autopilot,
as required.
Note:
From this point, you must use a keypad type appropriate
to the display type you have selected.
to display the Configure this display
to display the Display type setup
ST70+ User Reference Manual
OK
System configuration
Now configure each
display type, group
and order. Then
link one or more
keypads to that
group.
Press OK to continue
Configure this display
Select each display in turn. Press OK to
i
configure. When all done, press MENU.
Press OK to configure this display
Display type
Autopilot
Configure this display as an instrument or
i
autopilot controller
Press OK to accept
Group
Number